|
Designed and manufactured by
Technics, Inc.
to allow a full cure for solid surface
resins. These ovens are fueled by natural
gas or L.P. which is less expensive to
operate and provides a quicker heat up ramp
time than electrically heated ovens. The gas
fired burner package features a modulating
flame control that enables the oven to reach
programmed temperatures quickly and maintain
a consistent internal temperature throughout
all levels of the oven. Electronic safeguard
programmer, flame detector and airflow
sensing switches monitor and control fuel
supply during operation. Any disruption to
airflow, gas supply or electrical power
automatically shuts down the oven until
manual reset is activated.
|
MODEL SW5-14-HGJA |
|
Product Curing: |
|
Solid surface sheet sizes:
maximum: 36 ½” x 148” x 1”,
minimum: 4” x 24” x ½” |
|
Solid surface sinks:
optional at upper level,
standard sizes up to 16”
deep |
|
|
Panel Controls: |
|
120
volt-50/60 hz.-1 phase 5 amp
service |
|
On/off switch and
indicator lights |
|
Programmable temperature
controller with L.E.D.
readout, capillary
probes for monitoring
temperature and high
limit safety switch |
|
|
Construction: |
|
Fully insulated galvanized steel
panels |
|
Width 4’-3”, height 6’-6”,
overall length 15’-10”, interior
clearance 13’-6” x 39” |
|
Five
level, each with an independent
access door, top level for sinks
for sheets, optional sixth level
available |
|
Roller conveyor decks, 39” wide
between frame, rollers on 6”
centers |
|
All
doors, top, and side walls
insulated with 2” rock wool
insulation |
|
|
|
Burner Packages: |
|
Factory mutual design, 170,000
BTU natural gas fired burner
with 1200 cfm blower, 380 cfm
induced draft exhauster for
combustion products venting
|
|
 |
|
Optional
L.P. fired
burner
package
available. |
|
Flame safe
guard
programmer
|
|
Blower and
ventilation
airflow
safety
switches |
|
Electronic
flame
safeguard
protection |
|
Safety shut
off main gas
valve
|
|
Manual
reset,
excess
temperature
safety
shutdown
controller
|
|
|
Optional side
mounted burner
package and control
panel for pass
through transfer of
sheet stock and
sinks |
 |
|
|
